BayTech DS2-RPC 2012 - Manual (Page 14)

Page
14
DS4(A)­RPC OPENING MENU
Figure 13: Admin User Configuration
Figure 14: Non-Admin User Configuration
The unit displays a list of modules installed in the
DS4 chassis, not all available slots have to be filled.
Type “5” or whatever number list the “DS-RPC”,
and press ‘Enter’ Configuration
DS62 module #1..........1
DS74 module #2..........2
DS74 module #3..........3
DS74 module #4..........4
DS-RPC module #5..........5
NOTE: Module #1 in slot 1 is for the Host module. Module #2-4 in slots 2-4 are the DS74-
Peripheral module which connects to the external devices. Module #5 is the outlet module located
internal to the chassis. Refer to the individual Host and DS74 manuals to configure these modules.
With a valid connect to the host module; you should get
the following Host Module menu. Type “C” at the prompt
and press ‘Enter’ to display the module configuration
menu. Module:
Attention Character: ;
Device A ................1
Device B ................2
Device C ................3
Device D ................4
DS-RPC ................5
Configure.......................C
Status..........................S
Unit Reset......................RU
Logout..........................T
Enter Request :c
NOTE: Only the Admin user assigned to the First position in the manage users menu will have
the following options available: ‘Config’, ‘Lock’, ‘Unlock’ and ‘Clear’.
On n --Turn on an Outlet, n=0,1...4,all
Off n --Turn off an Outlet, n=0,1...4,all
Reboot n --Reboot an Outlet, n=0,1...4,all
Status --DS-RPC Status
Config --Enter configuration mode
Lock n --Locks Outlet(s) state, n=0,1...4,all
Unlock n --Unlock Outlet(s) state, n=0,1...4,all
Current --Display True RMS Current
Clear --Reset the maximum detected current
Temp --Read current temperature
Voltage --Display True RMS Voltage
Logout --Logoff
Logoff --Logoff
Exit --Logoff
Password --Changes the current user password
Whoami --Displays the current user name
Unitid --Displays the unit ID
Help --This Command
Type "Help" for a list of commands
DS-RPC>
On n --Turn on an Outlet, n=0,1...4,all
Off n --Turn off an Outlet, n=0,1...4,all
Reboot n --Reboot an Outlet, n=0,1...4,all
Status --DS-RPC Status
Current --Display True RMS Current
Temp --Read current temperature
Voltage --Display True RMS Voltage
Logout --Logoff
Logoff --Logoff
Exit --Logoff
Password --Changes the current user password
Whoami --Displays the current user name
Unitid --Displays the unit ID
Help --This Command
Type "Help" for a list of commands
DS-RPC>