BayTech DS2-RPC 2012 - Manual (Page 12)

Page
12
Detail Operations and Configurations
DS2­RPC Opening Menu
DS2­RPC CONFIGURATION MENU
Change Password
Change Outlet Name
A valid connect to the host module, you should get the
following menu.
NOTE: Module #1 in slot 1 is the Host module.
Module #2 in slot 2 is the DS74 module. Refer to
the individual Host and DS74 module for their
configuration.
Module:
Attention Character: ]
Device A ................1
Device B ................2
Device C ................3
Device D ................4
DS-RPC ................5
Configure.......................C
Status..........................S
Unit Reset......................RU
Logout..........................T
DS-RPC Power Control
(C) 1997 by BayTech
Rev. F0.15
1)...Change Password
2)...Change Outlet Name
3)...Enable/Disable Confirmation
4)...Enable/Disable Status Menu
X)...Exit
Enter Request: 1
Select 1), to change the “Admin” user password.
If the Admin has a password, enter the current
password before entering the new password.
Configuration
DS62 module #1..........1
DS74 module #2..........2
DS-RPC module #3..........3
Enter new Password:
Re-Enter new Password:
Enter Current Password:
Enter new Password:
Re-Enter new Password:
Select 2), to change the names of the outlets. The unit will display a list of the
outlet’s names.
Type the number of the outlet to be changed. If you want to change the name
of Outlet 4, type the number 4 at the “Enter Request” prompt, and press
‘Enter’ The unit displays the following:
Type the new name up to 16 characters
1)...Outlet 1
2)...Outlet 2
3)...Outlet 3
4)...Outlet 4
Enter Request:4
Enter :
The Configuration menu displays a list of modules
installed in the DS2 chassis. Type “3” for the “DS-
RPC”, and press ‘Enter’