Dodge 2007 Sprinter - Manual (Page 302)

301
Practical hints
Where will I find...?
5
3 Tensioning lever
4 Jack
5 Vehicle tool kit
̈ Remove the vehicle tool kit.
̈ Pull tensioning lever 3 upward and
unhook the retaining strap of jack 4.
̈ Remove jack 4 upward out of the re-
tainer.
If you are replacing the tires on the vehicle,
you may use the spare wheel as a road
wheel provided that:
ț the tires are no more than 6 years old
ț the wheel and tire have the same spec-
ified design as the road wheels
The spare wheel is located in a spare wheel
bracket under the rear of the vehicle.
More information about tire inflation pres-
sures can be found in the "Operation" sec-
tion ( ୴ page 213).
Panel van/crewbus
1 Cover
2 Recess
̈ Open the rear doors (୴ page 61).
̈ Insert a screwdriver into recesses 2
and pry off covers 1.
̈ Using the wheel wrench from the vehi-
cle tool kit ( ୴ page 300), now unscrew
the visible bolts approximately
20 turns counterclockwise.
i
Place the jack into the retainer as
shown when storing it back into place.
Make sure that the jack’s retaining
strap is hooked in and tensioned.
Spare wheel
! CAUTION
Check regularly that the spare wheel is
secured correctly.