Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 9)

Fig. 4-2-C
M8 x 16mm SBHCS
Front Leg Brace Left
Fig. 5-1
M6 Connector Bolt
M6 Plastic Washer
Fig. 5-2
Fig. 5-3
M6 x 8mm Set Screw
Track Coupler
Fig. 5-4
Rear Track Assembly Side
Plastic Track
Back Track Support
Front Track Support
Back Track Support
Page. 8
4-2-C: Attach the Front Leg Braces to the Table As-
semblies and Frame Ends. (Fig. 4-2-C)
4-3-C: Securely fasten all the M8 x 16mm SBHCS in
this Step and from Step 3-C.
Parts Needed:
2- Track Coupler
4- 10 ft Plastic Track
8- M6 x 8mm Set Screw
Tools Required:
3mm Allen Wrench
4mm Allen Wrench
5-1: Detach the pre-installed Track Support
from the Table Assembly by unfastening the
M6 Connector Bolts with a 4mm Allen Wrench.
(Fig. 5-1)
5-2: Insert the Track Coupler into the Track
Support end leaving approximately half of the
coupler exposed. (Fig. 5-2) Insert and fasten
M6 x 8mm Set Screws into the Track Support
end using a 3mm Allen Wrench. (Fig. 5-3)
5-3: Slide a Track Support end onto the
coupled back track assembly and fasten M6 x
8mm Set Screws with a 3mm Allen Wrench to
complete one 10 ft Track Support. (Fig. 5-3)
5-4: Slide the 10 ft Plastic Track down the
track groves of the Back Track Support Assem-
bly. (Fig. 5-4)
5-5: Repeat step 5-2 to 5-4 to assemble the
10 ft Front Track Support Assembly.
5-6: Loosely fasten the Front Track Assembly
and securely fasten the Rear Track Assembly
onto the Table Assembly with Connector Bolts
and M6 Plastic Washers. The Rear Track As-
sembly side should be flush with the back edge
of the table. (Fig. 5-1)
Note: The Front Track Assembly will be ad-
justed and tightened in step 9.
Step 5: Track Assembly for King Size Frame