Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 15)

Fig. 12-3
Front Rail Bracket Non-Ratchet rear coupler
Fig. 12-4
Rail Clamp Lock Pin Assembly
M6 x 16mm SBHCS
Idler Rail Assembly clamp locking end key
Rail Clamp Lock Pin end key
Fig. 12-1
Idler Rail Assembly clamp locking end
Front Rail Bracket Ratchet End rear hole
Fig. 12-2
Clamp Lock Rail End Key
Foward
Page. 14
12-4: Align the keyed ends of the Idler Rail Assembly clamp locking end with the Rail Clamp Lock Pin end.
Attach the Rail Clamp Lock Pin Assembly to the Idler Rail Clamp Locking Assembly by fastening the M6 x
16mm SBHCS with a 4mm Allen Wrench. (Fig. 12-4)
Parts Needed:
1- Idler Rail Assembly
1- Rail Clamp Lock Pin Assembly
1- M6 x 16mm SBHCS
Tools Required:
4mm Allen Wrench
Note: This assembly step is universal for
both Crib and King size frames.
12-1: Insert the Idler Rail Assembly
through the throat of the machine and
clamp locking end into the Front Rail
Bracket Ratchet End rear hole. (Fig. 12-1)
12-2: Rotate the Idler Rail Assembly so
that the Clamp Lock Rail End square Key is
facing forward. (Fig. 12-2)
12-3: Clip the Non-Ratcheting Floating
End into Front Rail Bracket Non-Ratchet
rear coupler. (Fig. 12-3)
Step 12: Idler Rail Clamp Attachment to Frame