Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 16)

Fig. 14-1
Fig. 14-2
M10 x 80mm SBHCS
M10 x 125mm SBHCS
M10 Washer
Handwheel Assembly
Handwheel Coupler
Fig. 13-1
Rail Ratchet End
Ratching End
Non-Ratcheting End
Rail Holder
Fig. 15-1
Page. 15
Parts Needed:
1- Handwheel Assembly
1- Handwheel Coupler
1- M10 Washer
1- M10 x 125mm SBHCS
Tools Required:
6mm Allen Wrench
Note: This assembly step is universal for both
Crib and King size frames.
14-1: Remove the M10 x 80mm SBHCS from
the existing Take Up Rail Assembly with a 6mm
Allen Wrench. (Fig. 14-1)
14-2: Fasten Handwheel Coupler, Handwheel
Assembly, M10 Washer, and M10 x 125mm
SBHCS with a 6mm Allen Wrench to the end of
the Rail Assembly from Step: 14-1. (Fig. 14-2)
Step 14: Handwheel Attachment to Rail End
Parts Needed:
4- Rail Assembly
Note: This assembly step is universal for
both Crib and King size frames.
13-1: Insert the Rail Assembly through
the throat of the machine and Ratcheting
End into the Rail Ratchet End of the take
up rail ratchet assembly. (Fig. 13-1)
13-2: Clip the Non-Racheting End of the
rail into the Rail Holder of the take up rail
non-ratchet assembly. (Fig. 13-1)
13-3: Similar to Steps 13-1 and 13-2
install the remaining rails into their corre-
sponding frame ends. (Fig. 13-1)
Step 13: Rail Attachment to Frame
Tools Required:
1- Open Wrench 17mm
Step 15-1: Adjust leveling feet with the 17mm Open Wrench so
that the machine remains stationary without interaction from the
user. To raise the leg of the machine simply turn the foot clock-wise
shown in Fig. 15-1 and reverse action to lower the foot.
Step 15: Leveling Feet Adjustment