Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 6)

Fig. 1-1
Fig. 1-2
Fig. 1-3
Fig. 2-1
M8 Hex Nut
M8 Flat Washer
M8 x 55mm SBHCS
Right Frame End
Left Frame End
Top Rail Ratchet
Assembly (Right)
Rail Holder Assembly
(Left)
Page. 5
Frame Assembly
Parts Needed
1- Right Frame End
1- Left Frame End
1- Top Rail Ratchet Assembly
1- Rail Holder Assembly
Tools Required
4mm Allen Wrench
1-1: Insert the Top Rail Ratchet Assembly into the Right Frame End tube end
and tighten the M6 x 25mm SBHCS. (Fig. 1-2)
1-2: Insert and fasten the Rail Holder Assembly into Left Frame End tube
end. (Fig. 1-3)
Parts Needed
1- Right Frame End
1- Left Frame End
1- Middle Leg
Tools Required
5mm Allen Wrench
Open Wrench 13mm and 10mm
Height of Fabric Surface Chart
(Height is determined by the quilting surface to the floor.)
Top Hole 44” 4th 39”
8th 43” 3rd 38”
7th 42” 2nd 37”
6th 41” Bottom Hole 36”
5th 40”
2-1: To adjust the legs, remove the pre-installed M8 x 55mm
SBHCS, M8 Flat Washer, and M8 Nylock Nut from the frame
ends and middle leg if assembling in King size. (Fig. 2-1)
2-2: Adjust the leg height using the Height of Fabric Surface
Chart. The bottom of the machine handles typically start at
about 8” above the Quilting surface. Determine what setting
will be most comfortable for you based on your height.
2-3: Fasten the M8 x 55mm SBHCS, M8 Flat Washer, and M8
Hex Nut to the adjusted legs with the tools provided. (Fig.
2-1)
Step 1: Ratchet and Rail Holder Installation
Step 2: Height Adjustable Leg Assembly