Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 14)

Fig. 10-1-C
Fig. 10-2-C
Rail Ratcheting End
Non-Ratcheting End Insert
Idler Rail Clamp Locking Assembly
Idler Clamp Floating Insert
M6 Set Screws
Fig. 11-1
Magnet Bracket Spacer
Magnet Bracket
1/4 inch Hex Bolt
Fig. 11-2
Hinge
Hinge
Page. 13
Parts Needed:
4- Rail Ratcheting End
4- Rail Non-Ratcheting End
1- Idler Rail Clamp Locking
Assembly
1- Idler Clamp Floating Assembly
8 - M6 x 10mm Set Screws (Pre-
installed in the Rail Couplers)
Tools Required:
3mm Allen Wrench
4mm Allen Wrench
6mm Allen Wrench
10-1-C: Unfasten the Non-Ratcheting End Insert from a Rail Non-Ratcheting End with a 6mm Allen Wrench.
Insert and fasten the Non-Ratcheting End Insert into the Rail Ratcheting End. (Fig. 10-1-C)
Note: If the rail end is difficult to remove, loosen the bolt half way out. Push in the bolt to release the com-
pression cone, which will allow the rail end to be easily removed.
10-2-C: Repeat step 10-1-C for the remaining 3 rail ends.
10-3-C: Unfasten the Idler Clamp Floating Insert from the Idler Clamp Floating Assembly by removing four
M6 Set Screws with an M3 Allen Wrench. Insert and Fasten the Idler Clamp Floating Insert into the Idler Rail
Clamp Locking Assembly. Align the Clamp Rails so that the hinges are on the same side. (Fig. 10-2-C)
Step: 10-C: Rail Assembly for Crib
Parts Needed:
1- Magnet Bracket
1- Magnet Bracket Spacer
1- 1/4 x 1 inch Hex Bolt
Tools Required:
1- 7/16 inch Wrench (Not provided with frame
contents.)
11-1: Remove the 1/4 x 1 inch hex bolt from the rear
right machine wheel. Align and fasten the Magnet
Bracket Spacer, Magnet Bracket, and 1/4 x 1 inch Hex
Bolt. (Fig. 11-1)
11-2: Place the Machine on the Bottom Carriage. (Fig.
9-3)
Note: Magnet Bracket Spacer is not used when using a
Pro-Stitcher system. This assembly step is universal for
both Crib and King size frames.
Step 11: Machine Magnetic Bracket