Baby Lock Momentum Quilting Frame (BLQM) Instruction and Reference Guide - Manual (Page 17)

Fig. 16-1
Fig. 16-2
Fig. 16-3
Fig. 16-4
Fig. 16-5
Ethernet Cable Long
Power Supply Cable
Motor Cable
Ethernet Port
Ethernet Cable
Ethernet Cable Short
Middle Leg
Motor Cable
Tab
Right Frame
End
Right Frame
End
Fig. 16-6
Master Board Box
Power Supply
Page. 16
Parts Needed:
1- Ethernet Cable Short
2- Ethernet Cable Long (Pre-installed on frame
ends)
1- Power Supply
2- Motor Cable (Pre-installed on frame ends)
16-1: Plug the Ethernet Cable Short into the Ethernet
ports on the underside of the Table Assemblies between
the Middle Leg. (Fig. 16-1)
Note: Step 16-1 is only required for King size frame as-
sembly.
16-2: Plug the Ethernet Cable Long, Power Supply Ca-
ble, and Motor Cable into the corresponding ports in the
Right Frame End. The Motor Cable Tab must be oriented
upward. (Fig. 16-2 and Fig. 16-3)
16-3: Plug the Ethernet Cable Long and Motor Cable into
the corresponding ports on the Left Frame End.
Note: The Left Frame End does not require a power sup-
ply.
16-4: Plug the Ethernet Cables that are near the rear of
the Frame Ends into the Table Assembly Ethernet Port.
(Fig. 16-4 and Fig. 16-5)
16-5: Plug the Power Supply into the Master Board Box.
(Fig. 16-6)
Step 16: Wire Connection