Avery Dennison SNAP Webserver Manual - Manual (Page 5)

SNAP Printer Web ServerUsers Manual Version 1_2.doc Page 5 of 15
Obtaining a DHCP Address
The printer comes from the factory in DHCP mode. Simply connect your network
cable to the Ethernet connector on the Network Interface Card installed in the
printer and then turn the printer on.
Because the DHCP process may take some time, wait at least 1 minute after the
printer finishes its initialization (Ready light is on steady) before continuing.
There are two Ethernet connectors on the back of the
printer. One is on the motherboard, and one is on the
Network Interface Card installed in the printer. Do not use
the connector on the motherboard.
You must have a Network Interface Card option installed in
the printer. Contact Avery Dennison Customer Service to
purchase this option.
Network Interface Card
Motherboard. Do not use.