Avery Dennison Sierra Sport3 9433 Bluetooth - Manual (Page 2)

2
I n s t a l l i n g t h e B l u e t o o t h D e v i c e o n S i e r r a S p o r t P r i n t e r s
To install the Bluetooth device:
1.
Turn off the printer.
2. Open the hinged cable door by
loosening the two screws and lifting
up on the door.
3. Using a small, flat-tip screwdriver,
gently set the +5V/DTR switch to
+5V.
CAUTION: Set the +5V/DTR switch to
the +5V position; otherwise,
the Bluetooth device will be
inoperable.
4. Plug the Bluetooth device into the
printer’s DB9 serial port.
5. Press the spacer into the cavity by
the Bluetooth device (9460 only).
6. Apply the enclosed regulatory label over the
existing one on the bottom of the printer.
7. Close the hinged cable door and tighten the screws.
8. Turn on the printer.
You need to configure the printer before you can use the Bluetooth device.
See “Setting Up Using the Bluetooth Menu,” for more information.
New Regulatory Label
Spacer
Bluetooth Device
Set +5V/DTR
Sw itch
to +5V
9460
Printer
9433 Printer
9493 Printer