Avery Dennison Renegade 4 9490 Wall Chart - Manual (Page 4)

LED INDICATOR TROUBLESHOOTING REFERENCE
LED States Solid Fast Blink
(
1 ⁄
4
second)
Slow Blink
(2 seconds)
GREEN Ready...
On-Demand Label Ready Low Battery
AMBER Ready...
Continuous Packet Syntax Error Printhead Hot...Wait
AMBER/
GREEN N/A Hardware Error or
printer failure Imaging Error
PRINTING A TEST LABEL
Before you call for service, print a test label. The label contains information to help
Service diagnose mechanical and setup problems.
1. Turn the printer off and disconnect the host from the printer.
c
It is impor tant that you disconnect the host from the printer before
printing a test label. This could cause problems at the host.
2. While pressing the trigger, turn the printer on. Hold the trigger down and watch
the LED. Then, wait until the LED turns off, and release the trigger.
n
If the printer is in On-demand mode, the LED rapidly blinks green.
Press the trigger to dispense the test label. If the printer is in
Continuous mode, a test label prints automatically.
For supplies, sales and service, call TOLL FREE:
1-800-543-6650 (In the U.S.A.)
1-800-263-4650 (In Canada)
www.monarch.com
TRADEMARKS
Monarch® and Renegade® are trademarks of Monarch Marking Systems, Inc.