Avery Dennison Renegade 4 9490 Wall Chart User Manual

Charging the battery, Clearing jams

CHARGING THE BATTERY

1. Turn the printer off.

2. Remove the battery from the printer.

3. Plug the charger’s connector into the

battery socket. The charger’s LED
indicator is solid amber when the
charger is fully connected.

4. Plug the charger into a grounded

electrical outlet of the correct voltage:

✦ trickle charger takes 8 hours
✦ fast charger takes about 2 hours

5. Unplug the charger from the battery

when charging is complete.

CLEARING JAMS

The LED flashes amber and green when a
jam occurs.

1. Turn the printer off and open the printer

(see decal on the back of the printer).

2. Remove the label roll and any jammed

labels.

3. Clean the printer to remove build up

(see "Cleaning the Printer" below).

4. Reload the label roll. Close the printer

and turn it on.

R E N E G A D E

Refer to the

Operator’s Handbook

for more details on these procedures.

Battery
Charger

Battery

Connector

Label
Roll

See also other documents in the category Avery Dennison Equipment: