Avery Dennison LOKPRINT I - Manual (Page 8)

8 •••• 1. Operation Users Manual LOKPRINT™
1.3 Recommended Spare Parts
The following spare parts are recommended for each facility that has a machine:
Spare Parts Kit 220010 115V/230V contains the following parts.
Part # Description Qty
101102 Thermocouple (30") 2
101103 Heat Element 110V (200W) 4
224048 Spring, Fabric lift, Music wire 1
241149 Static, Anti-Static glove 2
351102 Printhead, 6X6, 300DPI 1
358018 1/5P 40T Timing belt 1
371131 Ink out sensor harness 1
375026 Roller, Alt 1
375030 Roller molded, Alt 1
514090 Assembly, Tape idler roller 1
921122 Fuse, 5.0A 250V TD 1/4 X 1 1/4 1
921167 Fuse, 10A, 1/4" X 1 1/4" 2
921168 Fuse, 10A, 5 X 20mm 2
990444 M3 X 14mm Cap screw 2
990688 Fuse, 2.5A 250V SB 5x20mm 2
990754 Fuse, 1.0A 250V F.A. 5 x 20mm 2
990765 Fuse, 4.0A 250V Time delay 2
991106 Spring, Extension 2
991113 Drive, Timing belt, 54T X ¼" 1
1.4 Set-up of the Machine
When initially installing the Machine, the following items must be accomplished:
- Locate the template under the feet on the right hand side of the printer, then lay the
feet of the LOKPRINT in the remaining holes, this provides the proper spacing
needed for operation.
- CHECK THE POWER SOURCE VOLTAGE FIRST. Check to make sure
the machine has been configured for the correct line voltage (see section 1.4.1
Main Fuse Configuration). If the power available is subject to power surges, a
surge suppresser must be placed in the incoming power line. The power
consumption is ~1000 watts. Connect the power cord to a grounded 115 or 230
volt AC electric outlet of sufficient power.