Avery Dennison ALX 924 Operating Manual - Manual (Page 10)

09/06 Rev. 3.06-01 OPERATING MANUAL Device Description
ALX 92x
10
Basic operating procedures
Connecting the device
1. Ensure that the power switch is set to “0” (off).
2. Connect the device to the power supply using the cable [6B] provided.
3. Using the data cable supplied, connect the Centronics interface [6A] on the
device to the host computer.
[6] Sockets for the Centronics cable (A) and power cable (B) on the ALX 92x.
4. Turn on the device using the power switch (set to position “1”).
5. Hold the on / off switch in the control panel depressed for approx. 2 seconds.
The following sequence of messages is displayed:
WARNING!
The device operates using mains voltage! Touching electrically live parts
may expose you to hazardous electrical currents and may lead to burns.
« Make sure that the device is switched off before connecting the power
cable.
« Only operate the device using the system voltage indicated on the
nameplate.
« Only connect the device to a grounded power socket fitted to authorised
standards.
« The power cable should be run to the device so that
– nobody will trip on it, and that
– the power plug can easily be pulled out if necessary.
« The power cable should not be more than 3 meters long.
System start... The boot loader is starting.
System start...
Start user prog Valid firmware recognised, program is starting.
A
B