Avery Dennison Monarch 9864 Quick Reference - Manual (Page 20)

06/08 Rev. AA QUICK REFERENCE
9864
18
¯
The printhead does not need to be removed. Mark the position of the
printhead on the axle, if it is not flushed against the inner or outer plastic
ring.
4. Moisten a lint-free cloth with isopropyl alcohol and wipe the printhead clean.
You can also use a cleaning pen (114226).
Fig. 1 Cleaning the printhead – the
printhead does not need to be
removed (Fig: Dispenser
version).
5. Return the printhead mounting to its original position and tighten the thumb
screws.
¯
Press the thumb screw on the tapered edge of the square axle to ensure
the exact positioning of the printhead mounting on the axle. Also pay
attention to the position of the printhead in relation to the edge of the label.
The printhead should be flush against the inner black plastic plug.
6. Connect the printhead cable before turning on the printer.