Avalon Firestyles Vashon-1998 to 1999 - Manual (Page 32)

32
Optional Equipment
Travis Industries 9 3 5 0 8 1 0 2 0 9 1 0 0 2
2 Attach the rheostat and rheostat wires following the directions below.
PILOT
IGNITER
Attach the blower sticker
to the control panel (make
sure it is centered over
the large hole).
BLOWER
LO
OFF
HI
11/16" Wrench
PILOT
IGNITER
BLOWER
LO
OFF
HI
NOTE: this tab fits into the
hole on the mounting
bracket.
Attach the rheostat to the control panel
with the included nut.
Attach the knob.
Connect the wires labeled
ÒRheostat WiresÓ from the stove
to the wires on the rheostat
(orientation does not matter).
PILOT
IGNITER
BLOWER
LO
OFF
HI
a b c
Remove the button plug by prying
it loose with a screwdriver.
3 Install the snap disk following the directions .
Control
Panel
Snap Disk Bracket
(attached to stove)
Snap Disk
Slide the snap disk into the snap
disk bracket. Attach the black
and white snap disk wires to the
snap disk (orientation does not
matter). Use a lock tie to secure
the wire away from the burner
pan to prevent burning.
Snap Disk
Wires
4 Install the blower mounting hardware onto the left and right fan mounting bracket.
Install the grommets (with spacers
inserted inside), and washers onto one
bracket. Attach the nuts to secure.
Repeat for the opposite side.
11/32" Nutdriver
a b Insert the brackets onto
the blower assembly.
The slots on the blower
assembly slide into the
gaps in the rubber
grommets.
Top View
Blower Assembly
Blower
Bracket
Rubber
Grommet
Washer
Nut
Spacer