Avalon Firestyles Vashon-1998 to 1999 - Manual (Page 30)

30
Optional Equipment
Travis Industries 9 3 5 0 8 1 0 2 0 9 1 0 0 2
4 Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice. The
propane conversion kit includes a .016Ó (labeled LP 16) or .011Ó (labeled LP 11) pilot orifice. The
.016Ó orifice is preferred because it allows for greater pilot adjustment.
Remove the pilot
hood assembly by
unscrewing the two
attachment screws.
Pilot Orifice
LP (Propane) Orifices
Pull the pilot orifice
retainer and pilot orifice
upwards to remove.
Pilot Orifice
Retainer
Phillips
Screwdriver
Pilot Hood
Assembly
1 1
P
L
Orifice Identification:
1 6
P
L
(preferred)
NG (Natural Gas) Orifices
1 8
N
2 1
N
(preferred)
5 Remove the pilot orifice. It may be resting on the pilot tube or lodged inside the pilot assembly (tap
the assembly from above until it falls out). Place the propane pilot orifice onto the pilot tube (the LP
orifice is .016Ó diameter - it has Ò16Ó stamped on it). Insert the pilot tube (with orifice) into the pilot tube
port and tighten the compression nut until tight. NOTE: Leak test this connection after the heater is
installed and gas is connected.
6 Replace the pilot assembly (follow the instructions in step 4 in reverse order). Make sure the pilot
assembly gasket is placed correctly.
7 Replace the burner pan (see step 3). Install the logs and embers. Close the door.