Avalon Firestyles D-V-1995 - Manual (Page 9)

I
NSTALLATION
(C
ONT
.)
P AGE 9
+ Before attaching the rear panel, you need to set the restrictor position. See the section
"Approved Vent Configurations" to determine which restrictor position is required and how
to adjust the restrictor.
5 Attach the on/off switch to the rear panel. Attach the rear panel to the stove and the gas inlet cover
to the rear panel (see the illustration below).
Slide the nine U-Nuts onto the holes
on the top and side panels (with the
flat portion out).
U-Nut
Back of Heater
Rear Panel
Disconnect the power cord at the molex connection and insert it
through the hole in the lower right of the rear panel. Then re-
attach the power cord to the heater.
Attach the rear panel to the
heater with the twelve 10-24
self-tapping screws. Use a
5/16" nutdriver to tighten.
5/16" Nutdriver
Molex
Connection
Detach the two red wires leading to the on/off switch.
Insert the switch into the hole in the upper left of the rear
panel until it locks in place. Then re-attach the two red
wires from the heater to the upper two posts on the switch.
Jumper Wire
(leave in place)