Avalon Firestyles D-V-1995 - Manual (Page 34)

P AGE 34
O
PTIONAL
E
QUIPMENT
Propane (LP) Burner Pan
(Part # 98900740)
1 Remove the LP burner pan from the packaging and remove the two screws holding the boxing
brackets in place with a 5/16" nutdriver. Keep the packaging, boxing brackets, and screws. They are
used to ship the natural gas (NG) burner pan back to Travis Industries.
2 Remove the door and glass from
the heater (see page 6 and 20).
3 Using a phillips-head
screwdriver, remove the 5
screws holding the natural gas
(NG) burner pan in place. Lift it
up and rotate it forward to
remove it from the firebox.
Attach the boxing brackets to it
with the screws removed in step
1 and place it inside the LP
burner pan packaging.
4 Place the LP label over the left
side of the serial number label,
thus replacing the NG
designation with the LP
designation (NOTE: this label is
attached by a chain to the heater
- see the illustration).
Use a 7/16" wrench to remove the four nuts
holding the boxing brackets in place.
Distinguishing Propane or Natural Gas Burner Pans
Natural gas burner pans have a blue mark here, propane
has a red mark. On the top of the burner pan there is an
"NG" stamped in the center front of the burner pan for
natural gas, "LP" for propane.
Boxing Bracket
Boxing Bracket
7
/16
" Wrench
5 Install the LP burner pan by rotating it into position. Replace the five screws removed in step 4 and
tighten. Connect the orange wire to the piezo igniter. Replace the glass (see page 22)
Connect the orange wire
to the piezo igniter.
Front of Heater
(with door &
glass removed)
Piezo Igniter
Attach the burner pan to
the stove with 6 1/4'-20
nuts (use a 7/16"
wrench to tighten). You
may access the nuts
from the rear.
Place the burner pan in
position. Tilt the burner
pan slightly forward to
allow the gas control valve
to insert into the heater.
Route the on/off switch
through the rear of the stove.
7/16" Wrench
Place the LP label over the left side of the serial number
label, replacing the NG designation with LP.
6 Fill in the PRA form included with the kit. Remember to include the serial number of the heater.
Then ship it, along with the un-burned NG burner pan, to Travis Industries for credit.
¥ No credit will be issued if the NG burner pan is damaged, incomplete, or if it was burned.
¥ Incomplete PRA forms will delay credit.