Avalon Firestyles D-V-1995 - Manual (Page 10)

P AGE 10
I
NSTALLATION
(
CONT
.)
6 Pull gently on the power cord to take out any extra slack. Place the strain relief included with the
stove over the cord and push it into the hole in the rear panel (see the illustration below).
Strain Relief
Power Cord
Compress the strain
relief from the top and
bottom and insert it
into the hole until it
locks in place.
TO INSTALL THE
STRAIN RELIEF
7 Attach the control cover by sliding it over the attachment hooks. Place the black grill in place.
The control cover hangs on two sets of hooks on both sides. Align
the control cover and slide the bracket onto the hooks and then
move downwards.
Bracket on
Control Cover
Hooks on Side of Heater Control Cover
Grill
Gas Inlet Installation
¥ Apply thread sealant to
one end of the gas inlet
and insert it through the
rear panel and into the
90
°
elbow on the gas
control valve. Tighten
with a pipe wrench.
! Leak check all gas line
connections.
Rear Panel
Gas Inlet
(3/8" diameter pipe)
17-1/4" NOTE:
Apply thread sealant
prior to installing.
Insert the gas inlet
into the hole
nearest the center.