beautypg.com

Nstallation – Avalon Firestyles D-V-1995 User Manual

Page 23

background image

I

NSTALLATION

(C

ONT

.)

P

AGE

23

¥

Let the stove burn for fifteen minutes. Adjust the air shutter, if necessary, to achieve the correct
looking flame (see the illustration below). The air shutter adjusts the amount of air that mixes with
the gas before it exits the burner holes. It is used to fine-tune the flame for differences in altitude
and vent configuration.

Gas Control Valve

PILOT ADJ

VENT

T

O

L

PI

ON

OFF

HI

LO

Correct

Flames should be blue at the
base, yellow-orange on the top.

If the flames are over 12" tall or sooty
on the ends, push up on the lever.

If the flames are all blue and
short, pull down the lever.

Not Enough Air

Too Much Air

Locate the air shutter adjustment
lever behind the gas control valve.
Move it up or down until the flame
looks correct. Pushing up gives the
flame more air (making it bluer).
Pulling it down cuts air down,
making it more orange.

NOTE: If the air control is all the
way up, yet the flames remain
sooty, shut off gas to the fireplace
and contact a qualified gas service
technician.

NOTE: The logs must be installed correctly to
monitor the flame while adjusting the air shutter.

!

If the air shutter is in its fully open position, yet the flames remain sooty, shut off gas to the stove
and contact your Travis Industries Dealer for a remedy.

!

If the vent configuration is installed incorrectly the vent may cause the flames inside the stove to lift
or "ghost" Ð a dangerous situation. Inspect the flames after installation to insure proper performance.
If the vent configuration is correct, yet the flames are lifting or ghosting, shut off gas to the stove and
contact the dealer for information on remedying the problem.

The flames should burn right off
the top of the burner ports (if they
are too blue, adjust the air control).

If the flames are lifting, yet the
vent configuration is correct,
contact your dealer.

Burner Pan

Burner Ports
(consists of slots
and holes)

If the flames are ghosting, yet the
vent configuration is correct,
contact your dealer.

¥ Give this manual to the home owner and fully explain the operation of this stove.