beautypg.com

Quick guide – Auto-Zone Control Systems USB-Link 2 Technical Guide, Installation Instructions for the USB-Link 2 (Version 01E) User Manual

Page 4

background image

USB-Link 2

4

Technical Guide

Important Notes

Follow the included USB-Link 2 driver installation

instructions

(page 5).

Follow the connection and wiring instructions

(Figure 2, page 6) to connect and confi gure the
USB-Link

2.

If you use your USB-Link 2 on a network and after

installation you cannot view all controllers, you may
need an EPROM upgrade in your CommLink(s) and/
or

MiniLink(s).

See Troubleshooting in the back of

this guide on page 13 for further instructions.

Familiarize yourself with all system components and

review all documentation. Pay special attention to
“Cautions,” “Notes,” and “Warnings” since these may
keep you from experiencing unnecessary problems.

If you encounter any problems, please refer to the

Troubleshooting section of this guide fi rst. If you
can’t resolve the problem, please call WattMaster
Technical Support at our toll free number—
1-866-918-1100.

Quick Guide

Quick Guide

Follow the fi ve steps below to get your USB-Link 2 up and running
in no time.

WARNING:

You must install the USB drivers (Step 3 below)

before connecting the USB-Link 2 to your computer (Step 4 below).

Step 1:

Set your USB-Link 2’s confi guration switch to Stand

Alone

or

Network

(Figure 3, page 10).

Step 2:

Set your USB-Link 2’s communication speed switch to

Low Speed or High Speed (Figure 3, page 10).

Step 3:

Install the USB drivers from the included CD-ROM onto

your

computer.

Step 4:

Attach the USB cable to your USB-Link 2 and plug

the other end of the cable into your computer’s
USB

port

(Figure 2,page 6).

Step 5:

Attach the communication cable to your USB-Link 2

and connect the other end of the cable to the
Controller’s

communication

port

(Figure 2,page 6).

Step 6:

Install the included Prism 2 software on your

computer

(page 8).

Revised 10/01/12