Troubleshooting eprom software – Auto-Zone Control Systems USB-Link 2 Technical Guide, Installation Instructions for the USB-Link 2 (Version 01E) User Manual
Page 13

USB-Link 2
13
Technical Guide
Troubleshooting EPROM Software
Verifying CommLink II, CommLink III,
and MiniLink EPROM Software Versions
In order to view controllers with the USB-Link 2 on a networked
system, the CommLink II and III must have version 3.15 software or
later installed and the MiniLink must have version 3.14 software or
later installed. Please follow the directions to determine the current
software version.
NOTE:
If you purchased your CommLink II, III, or MiniLink
after January 1, 2007, there is no reason to check the
software version nor is it necessary to check the soft-
ware version of a CommLink IV or 5.