beautypg.com

Communication settings and led descriptions, Usb-link 2 10 technical guide, Usb-link 2 led descriptions – Auto-Zone Control Systems USB-Link 2 Technical Guide, Installation Instructions for the USB-Link 2 (Version 01E) User Manual

Page 10: Usb-link 2 switch settings

background image

USB-Link 2

10

Technical Guide

Communication Settings and LED Descriptions

Figure 3: USB-Link 2 Confi guration Switch, Communication Speed Switch, and LEDs

Communication Speed
The communication speed switch for low or high speed is found to the
left of the LEDs. See Figure 3 above. To set the communication speed
switch, insert a pen tip to move the switch up or down.

Low Speed

- The switch should be set to LOW if using an Orion

Controls System Controller.

High Speed

- The switch should be set to HIGH if using an AZ2

System Controller.

USB-Link 2 LED Descriptions

COMM -

Indicates communication activity between the USB-Link

2 and the controller(s) that the USB-Link 2 is connected to.
When this LED is fl ashing, data is being exchanged.

USB TX & USB RX -

Indicates communication activity between

the USB-Link 2 and the computer that the USB-Link 2 is con-
nected to. The LEDs will fl ash only when data is sent from Prism
2 to the USB-Link via USB.

NOTE: Whenever you change the confi guration or

communication speed setting on the USB-Link 2,
you must cycle the power to the USB-Link 2 by
disconnecting and reconnecting the USB power
supply cable.

USB-Link 2 Switch Settings

Confi guration Switch
The confi guration switch for stand alone or network mode is found to the
left of the LEDs. See Figure 3 above. To set the confi guration switch,
insert a pen tip to move the switch up or down.

Stand Alone - No MiniLink or CommLink

- The slide switch

on the USB-Link 2 should be set to “Stand Alone” when you are
trying to talk to a stand alone controller or multiple controllers on
a loop without a CommLink or a MiniLink wired to the
communications loop.

Network - MiniLink or CommLink connection

- The slide

switch on the USB-Link 2 should be set to “Network” any time
there is a CommLink or MiniLink wired to the communications
loop.

STAND ALONE

NETWORK

Configuration
Switch

LEDs

Communication
Speed Switch