Artesyn NITX-300-ET-DVI Installation and Use (August 2014) - Manual (Page 25)

Hardware Preparation and Installation
NITX-300-ET-DVI Installation and Use (6806800N97B) 25
 Confirm the feasibility of the operation
There are available spare parts of the components to be installed or replaced in the
equipment warehouse. When the available spare parts are lacking, contact Artesyn
Embedded Technologies for help in time. For details on how to get help from Artesyn
Embedded Technologies visit https://www.artesyn.com/computing.
Make sure that the new components are in good condition, without defects such as
oxidation, chemical corrosion, missing components, or transportation damage.
By reading this document, you are familiar with how to install and replace the component
and master the skills required by the operation.
 Check the environment
Make sure that the power supply, temperature, and humidity meet the operating
requirements for the board and its components. For details, refer to the respective system
documentation.
 Prepare the parts and the tools
Prepare the components to be installed or replaced.
When you hold or transport the components, use the special antistatic package. Prepare
the cross screwdriver, screws, plastic supports, cooling gel, and ESD-preventive wrist
strap.
 Confirm installation or changing position
Confirm the position where NITX-300-ET-DVI will be installed.
 If a serious problem occurs and cannot be solved when you install or replace the
component, contact Artesyn Embedded Technologies for technical support.
2.4 Board Thermal Management and Placement
NITX-300-ET-DVI provides a thermal management strategy. This includes CPU junction
temperature monitoring, one on-board fan connector, and can take the corresponding action
to protect the system during catastrophic overheating.