Artesyn NITX-300-ET-DVI Installation and Use (August 2014) - Manual (Page 24)

Hardware Preparation and Installation
NITX-300-ET-DVI Installation and Use (6806800N97B) 24
Shipment Inspection
1. Verify that you have received all items of your shipment.
2. Check for damage and report any damage or differences to customer service.
3. Remove the desiccant bag shipped together with the board and dispose of it
according to your country’s legislation.
2.3 Preparing the Installation Environment
Before you install or replace components, pay attention to the following:
 Wear an ESD-preventive wrist strap to prevent the static electricity from damaging the
device.
 Keep the area where the components reside clean and keep the components away from
heat-generating devices, such as radiator.
 Ensure that your sleeves are tightened or rolled up above the elbow. For safety purposes,
it is not recommended to wear jewelry, watch, glasses with metal frame, or clothes with
metal buttons.
 Do not exert too much force, or insert or remove the components forcibly. Avoid damage
to the components or plug-ins.
Environmental Damage
Improperly disposing of used products may harm the environment.
Always dispose of used products according to your country’s legislation and manufacturer’s
instructions.
The product is thoroughly inspected before shipment. If any damage occurred during
transportation or any items are missing, contact customer service immediately.