beautypg.com

2 power requirements, Table 4-2, Dc board power requirements – Artesyn Centellis 2000 User Card-10GE Installation and Use (May 2014) User Manual

Page 37: Board exchange

background image

Board Exchange

Centellis 2000 User Card-10GE Installation and Use (6806800H33C)

37

4.2.1.2

Power Requirements

Make sure that the board is used in Centellis 2000 AdvancedTCA shelf. If the module is used in
a Centellis 2000 DC version shelf, make sure it is connected to -48 VDC up to -60 VDC (rated
voltage), according to Telecommunication Network Voltage (TNV-2).

A TNV-2 circuit is a circuit whose normal operating voltages exceed the limits for a safety-extra-
low-voltage (SELV) under normal operating conditions, and which is not subject to over
voltages from telecommunication networks.

On board voltages are 5.0 VDC, 3.3 VDC and 1.0 VDC:

5.0 V voltage is generated from the -48 V AdvancedTCA power by a DC/DC converter with
galvanic isolation suitable for TNV-2 circuits.

3.3 V and 1.0 V voltages are derived from the 5.0 V power.

Shock

Half-sine, 11 mSec, 30 m/Sec

2

Blade level packaging
Half-sine, 6 mSec at 180 m/Sec

2

Free fall

-

200 mm/all edges and corners
1.0 m (packaged) per ETSI 300 019-2-2
(Blade level packaging)
100 mm (unpackaged) per GR-63-CORE

Table 4-1 Environmental Requirements (continued)

Feature

Operating

Non-Operating (packed state)

Table 4-2 DC Board Power Requirements

Feature

Value

Rated Voltage

-48 VDC to -60 VDC
US and Canada: -48 VDC

Operating Voltage

-39 VDC to -72 VDC
US and Canada: -39 VDC to -60 VDC

Input current

0.2 A

Centellis 2000 User Card-10GE power
dissipation

3.8 W maximum