beautypg.com

2 power supply holdup, 5 installing and removing sfp/ sfp+ modules – Artesyn Centellis 2000 User Card-10GE Installation and Use (May 2014) User Manual

Page 26

background image

Centellis 2000 User Card-10GE Hardware

Centellis 2000 User Card-10GE Installation and Use (6806800H33C)

26

2.4.2

Power Supply Holdup

The Centellis 2000 User Card-10GE complies with the requirements for board level voltage
transients as described in chapter 4.1.4.3. of PICMG 3.0 (AdvancedTCA) specification.

It satisfies the requirement of uninterrupted operation during a power failure of 5 ms.

2.5

Installing and Removing SFP/ SFP+ Modules

This section describes how to install and remove SFP and SFP+ modules.

Eye Damage
Optical SFP/SFP+ modules may emit laser radiation when no cable is connected.
Avoid staring into open apertures to avoid damage to your eyes.

Personal Injury and Damage of the RTM and SFP/SFP+ Modules
Installing and using SFP/SFP+ modules which are not fully certified and which do not meet
all relevant safety standards may damage the RTM and the SFP/SFP+ modules and may lead
to personal injury.
Only use and install SFP/SFP+ modules which are fully certified and which meet all relevant
safety standards.

Personal Injury
Optical SFP/SFP+ modules may be classified as laser products. When installing and using any
of these SFP/SFP+ modules, the regulations which correspond to the respective laser class
apply to the whole RTM. Not complying to these regulations, may lead to personal injury.
When installing and using optical SFP/SFP+ modules which are classified as laser products,
make sure to comply to the respective regulations.

SFP/SFP+ modules can be installed/removed both while the RTM is powered and non-
powered. The presence and also the type of SFP/SFP+ modules is automatically detected.

The maximum power consumption of all installed SFP/SFP+ modules must not exceed 12 W.