beautypg.com

Controls, indicators and connectors, 1 face plate, 1 leds – Artesyn Centellis 2000 User Card-10GE Installation and Use (May 2014) User Manual

Page 31: Table 3-1, Face plate leds, Figure 3-1, Face plate, Chapter 3

background image

Chapter 3

Centellis 2000 User Card-10GE Installation and Use (6806800H33C)

31

Controls, Indicators and Connectors

3.1

Face Plate

The following figure highlights the position of LEDs and connectors on the face plate of the
board. The LEDs and connectors are described in sections

LEDs

on page 31

and

Ethernet

Connectors

on page 32

.

3.1.1

LEDs

The following LEDs can be found on the face plate of the board. OOS, OK and H/S are ATCA LEDs
and can be controlled via IPMI. For more information, see the Centellis 2000 User Card-10GE:
Control via IPMI Programmer’s Reference
manual.

Figure 3-1

Face Plate

Table 3-1 Face Plate LEDs

LED

Color

Description

OOS (failure)

Red

Red: The Centellis 2000 User Card-10GE is out-of-service.
Off: The Centellis 2000 User Card-10GE is working properly.

OK (power)

Green

Green: The Centellis 2000 User Card-10GE is operating
properly.
Off: Otherwise
Blinking: The board boots up.

H/S

Blue

Blue: The Centellis 2000 User Card-10GE is ready to be
extracted.
Off: The Centellis 2000 User Card-10GE is not ready to be
extracted. Do not remove the board during this state.