Artesyn Centellis 2000 User Card-10GE Installation and Use (May 2014) - Manual (Page 32)

Controls, Indicators and Connectors
Centellis 2000 User Card-10GE Installation and Use (6806800H33C) 32
3.1.2 Ethernet Connectors
A SFP+ port located on the front panel allows for Ethernet connectivity from the payload to an
external device.
3.2 Sensors
The IPMC functionality is based on the IPMI specification V1.5.
The IPMI sensors on the Centellis 2000 User Card-10GE are shown Table 3-2 . For further
information, see the Centellis 2000 User Card-10 GE: Control via IPMI Programmer’s Reference.
Table 3-2 Centellis 2000 User Card-10GE Specific Sensors
Sensor Name
Sensor Type Code
Description Generate
Event Event/ Reading Type
Code
HotSwap HotSwap (F0h) Hot swap sensor Yes Sensor specific (6Fh)
Ejector_State Button (14h) Ejector state
sensor Sensor specific (6Fh)
IPMC_State OEM (D5h) IPMC state OEM
sensor Sensor specific (6Fh)
IPMB0_State IPMB (F1h) IPMB0 state
sensor Sensor specific (6Fh)
SFP_Enable Other FRU (1Ah) Enable/Disable
SFP Writable OEM
sensor No Type enable (9)
SFP_TXDIS Other FRU (1Ah) SFP TXDIS signal Yes Reading type failure (4)
SFP_LOS Other FRU (1Ah) Loss of signal
indication Yes Reading type failure (4)
SFP_TXFAULT Other FRU (1Ah) SFP transmit fault Yes Reading type failure (4)
SFP_PRESENT Other FRU (1Ah) SFP presence
sensor Yes Presence (8)
PMD_LOSS_SIGNAL Monitor IC (26h) Loss of signal
indication
Yes Reading type failure (4)
PMD_CMU_LOCK Monitor IC (26h) PMD CMU Lock
detect Yes Reading type failure (4)