Artesyn Centellis 2000 User Card-10GE Installation and Use (May 2014) - Manual (Page 15)

Chapter 1
Centellis 2000 User Card-10GE Installation and Use (6806800H33C) 15
Introduction
1.1 Overview
The Centellis 2000 User Card is an independent Field Replaceable Unit (FRU) for the Centellis
2000 system. It hosts an PHY for converting a 10 Gbps XAUI Ethernet signal to a Small Form-
factor Pluggable (SFP) connector on the face plate. It has independent power supply derived
from the 48 V and a 3.3V management supply. It supports full management access via two
IPMBs and accesses one Fabric Interface (FI) of the corresponding AdvancedTCA blade.
The Centellis 2000 User Card-10GE module is intended to be used in a CENT-2000 chassis. The
module when installed in the dedicated User Card slot provides uplink connectivity from the
payload Ethernet fabric channel.
Figure 1-1 shows the functional block diagram of the Centellis 2000 chassis including the two
10G User Cards in the lower part of the figure.