D-Link DI-707P - Manual (Page 29)

28
Using the Configuration Menu
Tools> Admin
Password-
Remote
Management-
To change the admin password, enter in the old password, and
enter the new password twice to confirm
You can change the admin password here. It is recommended that you change the
admin password from the default setting. The default password is blank (no password).
Remote Management allows the device to be configured
through the WAN (Wide Area Network) port from the Internet
using a web browser. A username and password is still
required to access the browser-based management inter-
face.
IP Address- Internet IP Address of the computer that has access to the
DI-707P. If the IP Address is set to 0.0.0.0, this allows all Internet
IP addresses to access the DI-707P.
Port- The port number used to access the DI-707P.
E.g., http://x.x.x.x:88, where x.x.x.x. is the WAN IP address of
the DI-707P and 88 is the port used for the Web Management
interface.