D-Link DI-707P - Manual (Page 22)

21
Using the Configuration Menu
Advanced > MAC Filters
MAC (Media Access Control) Filters are used to deny or allow LAN (Local Area Network)
computers from accessing the Internet and network by their MAC address.
At the bottom of the screen, there is a list of MAC addresses from the DHCP client
computers connected to the DI-707P. To use them, select one from the drop down list
and select an IP number you want to use. Then click the “Copy to” button and the
DI-707P will fill in the appropriate information to the list.
Disabled MAC Filter- Select this option if you do not want to use MAC filters.
Only allow computers with MAC address listed below to access the network-
Select this option to only allow computers that are in the list
to access the network and Internet. All other computers will
be denied access to the network and Internet.
Only deny computers with MAC address listed below to access the network-
Select this option to only deny computers that are in the list
to access the network and Internet. All other computers will
be allowed access to the network and Internet.
Enter the MAC Address of the client that will be filtered MAC Address-
Select this option for the specific IP filter policy to take effect.
Enable-