ARRIS TM508 Installation Guide - Manual (Page 26)

16
Touchstone Telephony Release 5 Standard 1.2 Mar 2007
Additional Items The following additional items are required, but not supplied, depend-
ing on the mounting surface.
• To mount the punch-down block on drywall, you need two dry-
wall anchors.
• To mount the punch-down block on plywood, you need two
1-inch #6 wood screws.
Action Perform the following tasks in the order shown.
Task Page
Mounting the Punch-Down Block .........................................16
Connecting Subscriber Wiring...............................................17
Mounting the
Punch-Down
Block Follow these steps to install the punch-block kit.
1 Place the punch-down block on the mounting surface at the desired
location. Mark the position of the mounting slots at the bottom left
and top right of the block. The following diagram shows the rear of
the punch-down block and the locations of the mounting slots.
2 After marking the mounting slot location, set the punch-down block
aside.
3 Drive the screws or drywall anchors into the mounting surface as
appropriate. Leave a gap of 1/4 inch (6mm) between the mounting
surface and the back of each screw head.
4 Slip the bottom mounting slot of the punch-down block.over the
bottom screw, then rotate the block so that the top mounting slot
slips under the top screw.
Mounting slots