ARRIS SBG6782 AC User Guide - Manual (Page 3)

Safety and Regulatory Information
SBG6782-AC Wireless Cable Modem & Router • User Guide i
365-095-23865 x.1
Safety and Regulatory
Information
IMPORTANT SAFETY INSTRUCTIONS
• Read This Before You Begin — When using your equipment, basic safety precautions should always
be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
• Read all of the instructions listed here and/or in the user manual before you operate this device. Give
particular attention to all safety precautions. Retain the instructions for future reference.
• This device must be installed and used in strict accordance with manufacturer’s instructions, as
described in the user documentation that is included with the device.
• Comply with all warning and caution statements in the instructions. Observe all warning and caution
symbols that are affixed to this device.
• To prevent fire or shock hazard, do not expose this device to rain or moisture. The device must not be
exposed to dripping or splashing. Do not place objects filled with liquids, such as vases, on the device.
• This device was qualified under test conditions that included the use of the supplied cables between
system components. To ensure regulatory and safety compliance, use only the provided power and
interface cables and install them properly.
• Different types of cord sets may be used for connections to the main POWER supply circuit. Use only a
main line cord that complies with all applicable device safety requirements of the country of use.
• Installation of this device must be in accordance with national wiring codes and conform to local
regulations.
• Operate this device only from the type of power source indicated on the device’s marking label. If you
are not sure of the type of power supplied to your home, consult your dealer or local power company.
• Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock.
Overloaded electrical outlets, extension cords, frayed power cords, damaged or cracked wire
insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.
• Route power supply cords so that they are not likely to be walked on or pinched by items placed upon
or against them. Pay particular attention to cords where they are attached to plugs and convenience
receptacles, and examine the point where they exit from the device.
• Place this device in a location that is close enough to an electrical outlet to accommodate the length of
the power cord.
• Place the device to allow for easy access when disconnecting the power cord of the device from the
electrical wall outlet.
• Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully
inserted with no part of the blades exposed.
• Place this device on a stable surface.
• Avoid damaging the device with static by touching the coaxial cable when it is attached to the earth-
grounded coaxial cable-TV wall outlet.
• Always first touch the coaxial cable connector on the device when disconnecting or reconnecting the
Ethernet cable from the device or user’s PC.
i