Setting up a wireless network connection – ARRIS SBG6782 AC User Guide User Manual
Page 21
Setting Up a Wireless Network Connection
SBG6782-AC Wireless Cable Modem & Router • User Guide
12
365-095-23865 x.1
Setting Up a Wireless
Network Connection
Your SBG6782-AC gateway and computer must have access to a Broadband or high-speed
Internet service before setting up a wireless network connection. Also, make sure your
computer and the SBG6782-AC are connected through an Ethernet connection.
Your SBG6782-AC gateway and computer must have access to a Broadband or high-speed
Internet service before setting up a wireless network connection. Also, make sure your
computer and the SBG6782-AC are connected through an Ethernet connection.
Choose one of the following options to set up your wireless network connection:
•
Launch the Quick Start Wizard to Set Up Your Wireless Network
•
Manually Set Up a Wireless Network on Your Computer
•
Connect Your WPS-Enabled Devices
After setting up your wireless network connection, check that the wireless network connection
was set up properly. See
Test Your Wireless Network Connection
Launch the Quick Start Wizard to Set Up Your Wireless
Network
The SBG6782-AC Quick Start Wizard is a six-step application to help you quickly configure your
basic wireless network settings. Depending on your home network setup, you can further
customize your wireless home network configuration after completing the wizard.
1. Open any web browser on the computer connected to the SBG6782-AC.
2. In the Address bar, type
http://192.168.0.1
for the SBG6782-AC Web Manager IP
address, and then press Enter. The gateway Login screen displays.
3. Type the default username and password. Both entries are case-sensitive.
Username: admin
Password: motorola
Note
: The gateway login process may differ slightly depending on if you purchased the
SBG6782-AC gateway from a retail store or if you received it from your service provider.
4. Click Login to open the SBG6782-AC Web Manager. The Launch Quick Start Wizard screen
displays (see Figure 4 on next page).
5. Click Launch Quick Start Wizard to start the wizard.
6. Click Next.
5