ARRIS WECB460 User Manual

Page 10

Option 2: Connecting to a Non-MoCA Network via Ethernet Cable

If the router or gateway present in the home network is not MoCA enabled,
you must connect the WECB460 Wi-Fi MoCA Bridge to the network using
Ethernet cable. The following diagram shows a typical installation.

Perform the following steps to install the WECB460 Wi-Fi MoCA Bridge.

Step 1: Connect the WECB460 Wi-Fi MoCA Bridge to the Router or Cable

Modem
Using an Ethernet cable, connect the Ethernet 1 connector on the
WECB460 Wi-Fi MoCA Bridge to an available Ethernet connector on the
router or cable modem.

Step 2: Connect any Direct Wired Client Devices

Using an Ethernet cable, connect any client devices, such as desktop or
laptop computers, to the Ethernet 2 connector on the WECB460 Wi-Fi
MoCA Bridge. (This should be a device located close enough to make a
direct wired connection practical.)

Step 3: Connect your Wireless Client Devices

Configure any wireless devices, such as laptop computers, notepads or
other mobile devices, to connect to the WECB460 Wi-Fi MoCA Bridge.
See

Setting Up your Wireless Client Devices

for instructions.