Analog Way Scan Vision VHX II - VHX480 - Manual (Page 6)

Chapter 2 : INSTALLATION SCAN VISION VHX II ™
PAGE 6
Chapter 2 : INSTALLATION
IMPORTANT : Please read all of the safety instructions (pages 2 to 4) before starting.
• Table top mounting: The SCAN VISION VHX II ™ can be used directly on a table: the unit is equipped with 4 plastic
feet.
• Rack mounting: The SCAN VISION VHX II ™ is compatible with a 19” enclosure. Please follow the instructions
below to install the SCAN VISION VHX II ™ in a 19” rack.
c Remove the 4 front side screws of the SCAN VISION VHX II ™ and fix the 19" optional
brackets to the sides with the 4 screws.
d Place the SCAN VISION VHX II ™ onto the optional 19" tray and place them in your rack.
e Attach together the SCAN VISION VHX II ™ with the 19" tray to the rack by using 4 screws in
the front panel holes (screws are not included).
f Connect all of the cables to the SCAN VISION VHX II ™ and attach them to the rack with
some tie wraps, to prevent the weight of the cables to pull down on the rear of the SCAN
VISION VHX II
™ .
IMPORTANT: • Be sure that no weight is added onto the SCAN VISION VHX II ™ .
• The maximum ambient operating temperature must not exceed 40 °C (104 °F).
• The rack and all mounted equipment in it must be reliably grounded to national and local
electrical codes.
(optional)