Section 4 maintenance -1, Introduction -1, Service information -1 – AMETEK GUPS 2400A-107 User Manual
Page 35: Spare and repair parts -1, Periodic maintenance -1, Maintenance
GUPS 2400A
–107 Operation Manual
4-1
SECTION 4
MAINTENANCE
4.1 Introduction
This section contains general information about maintenance of the GUPS 2400A-107. There
are no adjustments accessible to the user.
WARNING
Hazardous voltages are present when operating this equipment. Please
read the SAFETY NOTICE on page Error! Bookmark not defined. prior
to installation, operation, or maintenance.
4.2 Service Information
Questions concerning the operation, repair or service of this instrument should be directed to
the nearest Elgar representative or to the Elgar Service Department, Elgar Electronics
Corporation, 9250 Brown Deer Road, San Diego, CA 92121-2294. Include the model number
and serial number in any correspondence concerning this instrument. DO NOT return the unit
to the factory without prior authorization.
4.3 Spare and Repair Parts
When ordering spare parts or repair parts, specify the part name, part number, component
value and rating, and the Elgar part number, if available. If complete assemblies are required,
contact the Elgar Service Department.
Specify the assembly part number as marked on the assembly and the unit model number,
GUPS 2400A-107, when ordering.
4.4 Periodic Maintenance
The only maintenance required for this instrument is to periodically remove and clean or replace
the front panel fan filter.
The amount of time between cleaning is dependent on the environment in which the unit
is used. Dust and dirt accumulation in the air filter can cause restricted air flow and subsequent
overheating or reduced life on the internal components and batteries.