AMETEK MXCTSH Administrator Manual - Manual (Page 8)

MX Compliance Test System System Administrator Manual
2 Configuration Program
The chapter covers the various setup tabs available in the configuration program
(Ctsmxh_config.exe or Ctsmxl_config.exe). It also provides the required instructions to bring up
the protected area of the Config.exe program. The operator may use the Ctsmxl_config.exe or
the Ctsmxh_config.exe program at any time to display general setup and configuration
information. Without a password however, none of this information can be changed. In addition
to this general setup screen, there are hidden screens that may be used to change key system
parameters and test limits. These screens are also password protected.
2.1 Accessing the General Configuration Screen
Any operator of the MXCTS system can access the general configuration screen by selecting the
program shortcut for the Configuration program from the Windows Start menu. This shortcut is
located in the CTSMXH or CTSMXL program group.
Once a user name is provided (optional for read-only access), the user can click on the
"View/Update calibration information" button. The screen shown below will appear. Note that no
password entry is required to gain read-only access. The operator can review configuration data
shown but can make no changes to it.
This information is also covered by the MXCTSH User Manual (P/N 7003- 972) or MXCTSL User
Manual (P/N 7003- 973). Refer to this manual for further information on this screen.
Revision B 8