For flicker – AMETEK MXCTSH Administrator Manual User Manual
Page 17

MX Compliance Test System
System Administrator Manual
3.1.2 For
Flicker
Field
Description
Start Phase
See Harmonics
Fail window code
See Harmonics
Data Storage
Number of saves, first
section
See Harmonics
Number of saves, last
section
See Harmonics
Initial Buffer
Number of acquisition periods over which to determine steady state
condition.
Tolerances
Vrms Threshold
Minimum change in voltage required to be considered a voltage change. This
is effectively a noise threshold setting. Changes below the threshold value
are not considered as actual changes but noise.
Dc threshold
The low end cut off change for dc calculation
Limit or Min/Max
If this field is 0, min/max values for frequency, voltage and voltage deviation
are plotted.
Revision
B
17