American Time AllSync IQ - Manual (Page 14)

© American Time
14
AllSync IQ Installation Manual
Glossary
Appendix
Tr
oubleshooting
Installation
Intr
oduction
SiteSync IQ Installation Manual
Wired Signal Circuit Option
Wired Signal Circuit Installation
To install wired signal circuits (for electrical device control including bells, tone generators, lights, etc.):
1. Disconnect and lock out power to the AllSync IQ Master and any circuit wiring.
2. Remove the terminal block cover from the AllSync IQ.
a. Remove screws from each side of the cover.
b. Lift the cover up off the unit.
3. Route signal circuit wires into the wiring compartment of the System Controller.
a. Remove knockout(s).
b. Use copper conductors only.
c. Use strain relief connector fittings in the knockout holes to secure the wires.
d. Route the wires into the wiring compartment, leaving enough slack to make all connections to the relay terminals.
4. Connect signal wires to the circuit relay terminals.
a. Route the power (feed) line of each circuit to the COM terminal of the desired circuit (1-6) being connected.
b. Route the switched (load) line of each circuit to the NO terminal of the desired circuit (1-6) being connected.
c. Label the wires for each circuit as desired.
n Note: The signal circuits are protected with surge suppression components. In some applications, this protection can cause
leakage current to trigger the output device(s) when the circuit is switched ON. In these cases, the surge protection switches
(see illustration below) can be moved to the OFF position. Contact American Time Technical Support at 800-328-8996 with
any questions.
FUSED
SOURCE
DEVICES
LOW VOLTAGE
TRANSFORMER
STEP DOWN
POWER
BLACK
WHITE
= Bell
= Light
NO H N COM NC
CLOCK 1
NO COM NC
CLOCK 2
NO COM
BELL 1
NO COM
BELL 2
NO COM
BELL 3
NO COM
BELL 4
NO COM
BELL 5
NO COM
BELL 6
AllSync IQ Master Wiring Compartment Diagram
1:49
FRI OCT 3 2014
:45 AM
American Time 800-328-8996
1:49
FRI OCT 3 2014
:45 AM
American Time 800-328-8996