American Time AllSync IQ - Manual (Page 12)

© American Time
12
AllSync IQ Installation Manual
Glossary
Appendix
Tr
oubleshooting
Installation
Intr
oduction
AllSync IQ Installation Manual
Wired Clock Circuit Option
Wired Clock Circuit Installation
To install wired clock circuits:
1. Disconnect and lock out power to the AllSync IQ Master and any circuit wiring.
2. Remove the terminal block cover from the AllSync IQ.
a. Remove screw from each side of the cover.
b. Lift the cover up off the unit.
3. Route signal circuit wires into the wiring compartment of the AllSync IQ.
a. Remove knockout(s).
b. Use copper conductors only.
c. Use strain relief connector fittings in the knockout holes to secure the wires.
d. Route the wires into the wiring compartment, leaving enough slack to make all connections to the relay terminals.
4. Connect clock wires to the circuit relay terminals
NO H N COM NC
CLOCK 1
NO COM NC
CLOCK 2
NO COM
BELL 1
NO COM
BELL 2
NO COM
BELL 3
NO COM
BELL 4
NO COM
BELL 5
NO COM
BELL 6
Clock Circuit Terminals
Surge Supression
ON/OFF Switches
Clock Circuit Fuses
See Appendix H on Page 50 for Clock Circuit Wiring Diagram
1:49
FRI OCT 3 2014
:45 AM
American Time 800-328-8996
1:49
FRI OCT 3 2014
:45
AM
American Time 800-328-8996