Adtec digital EN-20 (version 2.03.06) Manual - Manual (Page 18)

multicast transmit purposes on
the indicated encode channel.
FEC Mode Forward Error Correction; selects
on/off. When selected, sends two
FEC RTP streams in addition to a
source RTP stream enabling a
receiver to reconstruct missing
packets in the source stream.
The RTP Control (above) must be
set to 'on' to enable FEC. On
Off
Available if RTP
selected 'on' *.ECMD0 FEP #
FEC L affects the maximum burstpacket
loss that can be recovered 4-20 *.ECMD FEP #
FEC D defines latency involved in
burstrecovery 4-20 *.ECMD FEP #
FEC TOSBITS sets the Type of Service (TOS)
bits in the IP header Normal
Minimize Cost
Maximize
Reliability
Maximize
Throughput
Minimize Delay *.ECMD0 FEP #
TOS Type of Service helps define how
the network should make
negotiate queuing between
throughput, delay, reliability, and
cost. Normal
Minimize Cost
Maximize
Reliability
Maximize
Throughput
Minimize Delay *.ECMD0 TOS #
TTL Time to live is a numeric value
from 1 to 255 that specifies the
number of iterations or
transmissions the packet can
undergo before it is discarded.
The default value is 7. 1 - 255 *.ECMD0 TTL #
Tx Connector The multicast connector
configuration determines whether
the IP stream will be sent out the
ethernet (10/100) or gigabit
(10/100/1000) ethernet port. ETHERNET
GIGE *.ECMD0 MCN #
Service Select *.ECMD0