Adtec digital EN-20 (version 2.03.06) Manual - Manual (Page 17)

IP Tx Menu
The following diagram represents the structure of the IP Tx Menu Menu:
Control/Settin
g Function Options API Command
Mode switches multicast function on and
off Off
Send *.ECMD0 MMO #
Tx IP Address The IP Address of which the
Multicast or Unicast is broadcast.
Multicast addressing supports the
transmission of a single IP
datagram to multiple receivers.
Valid Multicast addressing range is
224.10.XXX.XXX to
239.XXX.XXX.XXX. Unicast
addressing sends a single IP
datagram to only one receiver.
The Unicast address will be the
unique IP of the receiving device. user-defined;
numeric field in
format
xxx.xxx.xxx.xx
x *.ECMD0 MSI #
Tx Port port assignment used for
transmitting a multicast user-defined;
numeric field *.ECMD0 MSP #
DVB per IP Configures the amount of DVB
transport stream packets ( 188
bytes per DVB packet ) per IP
packet payload.
1
4
7
*.ECMD0 MSY #
RTP allows for sequence numbering
and timing for accurate playback. On
Off *.ECMD0 RTP #
TOS Type of Service; selects the type
of multicast that will forward the
packet. Normal
Minimize Cost
Maximize
Reliability
Maximize
Throughput
Minimize Delay *.ECMD0 TOS #
TTL Time-to-Live; specifies the
number of iterations or
transmissions the packet can
undergo before it is discarded user-defined *.ECMD0 TTL #
Multicast
Connector sets the physical connector (on
the rear of the unit) to use for Ethernet
!GigE *.ECMD0 MCN #