Adept T2 Pendant - Manual (Page 38)

Operation
38 Adept T2 Pendant User’s Guide, Rev D
4.16 System Menu
The System Menu provides the following functions:
• Adjust the LCD screen brightness (see Adjusting the LCD Screen Brightness )
• Set the initial Slow mode state (see Setting the Initial Slow Mode State )
• Enable/disable the LCD screen saver (see Setting the Screen Saver )
• Calibrate the LCD touchscreen (see Section 5.2 on page 43 )
• Clean the LCD touchscreen (see Section 5.3 on page 44 )
• Install a firmware update (see Section 5.1 on page 41 )
Figure 4-10. System Menu Screen
Adjusting the LCD Screen Brightness
The Brightness control (slider) allows you to adjust the LCD screen brightness for
optimum viewing in your environment.
• To darken the display (make it dimmer), move the Brightness control to the left.
• To lighten the display (make it brighter), move the Brightness control to the right.
When you have completed the adjustment, press OK to save your setting.
Setting the Initial Slow Mode State
The Initial Slow Mode State button allows you to specify the state of the SLOW mode
button at pendant startup. The Initial Slow Mode State button has three modes:
• Do Not Change - leaves the current SLOW mode button state unchanged
• Force On - toggles the SLOW mode button so that slow mode is enabled
• Force Off - toggles the SLOW mode button so that slow mode is disabled