Sensor select jumper, Reset switch, Stop/run switch – Zilog ZUSBOPTS User Manual

Page 23: Direction switch, Table 10, Sensor select jumper settings

UM026203-0115

MCU Module

MultiMotor Series Development Kit

User Manual

If the jumpers are placed in any combination other than those indicated in Table 9, the
system may not function properly.

Sensor Select Jumper

Due to pin limitations on some MCUs, the Sensor Select jumper is used to select between
operating in Sensored or Sensorless modes, as indicated in Table 10.

If the jumpers are placed in any combination other than those indicated in Table 10, the
system may not function properly.

Reset Switch

This switch resets the MCU.

Stop/Run Switch

This switch is used to turn the 3-phase motor ON and OFF.

Direction Switch

This switch is used to change the 3-phase motor’s direction of rotation.

This direction of rotation is determined by viewing the motor from the shaft end, and is
designated as Clockwise (forward) or Counterclockwise (reverse).

Table 10. Sensor Select Jumper Settings

Mode

Jumper Location

1-2

3-4

5-6

7-8

9-10

11-12

Sensored

Sensorless

Caution:

Note:

This manual is related to the following products:

Z16FMC2 Z16FMC3 Z16FMC6