Vectronics VEC-821K - Manual (Page 15)

VEC-821K Instruction Manual Super CW Filter Kit
install C2, be sure not to chip the ceramic material. Once installed, then
solder in place and trim the leads.
• 018. Locate capacitor C7 (.1uF). This is a disc ceramic type capacitor and will
be marked "104" or "104Z" (actual value in uF). Carefully install C7,
be sure not to chip the ceramic material. Once installed, then solder in
place and trim the leads.
• 019. Locate capacitor C3 (.1uF). This is a disc ceramic type capacitor and will
be marked "104" or "104Z" (actual value in uF). Carefully install C3,
be sure not to chip the ceramic material. Once installed, then solder in place
and trim the leads.
• 020. Locate capacitor C4 (.1uF). This is a disc ceramic type capacitor and will
be marked "104" or "104Z" (actual value in uF). Carefully install C4,
be sure not to chip the ceramic material. Once installed, then solder in
place and trim the leads.
• 021. Locate capacitor C6 (.1uF). This is a disc ceramic type capacitor and will
be marked "104" or "104Z" (actual value in uF). Carefully install C6,
be sure not to chip the ceramic material. Once installed, then solder in
place and trim the leads.
• 022. Locate capacitor C5 (.1uF). This is a disc ceramic type capacitor and will
be marked "104" or "104Z" (actual value in uF). Carefully install C5,
be sure not to chip the ceramic material. Once installed, then solder in
place and trim the leads.
• 023. Locate capacitor C8 (.01uF). This is a disc ceramic type capacitor and
will be marked "103" or "103Z" (actual value in uF). Carefully install
C8, be sure not to chip the ceramic material. Once installed, then solder in
place and trim the leads.
• 024. Locate diode D1 (1N34). This is a germanium diode and is made from a
clear glass type material. This part will have a band on one end indicating
the cathode end of the diode.
Remember diodes are polarity sensitive devices that must be installed correctly.
Always look for the banded or cathode end when installing, and follow instructions
carefully.
• 0 25. Insert D I into its mounting holes so the diode body rests against the
board. Be sure to observe the circuit marking indicating the cathode.
Solder in place and trim the leads.