Vectronics VEC-821K - Manual (Page 11)

VEC-821 K Instruction Manual Super CW Filter Kit
• 014. Insert R18 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 017. Locate resistor R5. This is 24.3K resistor (red-yellow-orange-red).
Carefully bend the leads close to the resistor body as in Step #1.
• 018. Insert R5 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 019. Locate resistor R8. This is 24.3K resistor (red-yellow-orange-red).
Carefully bend the leads close to the resistor body as in Step #1.
• 020. Insert R8 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 021. Locate resistor R10. This is 24.3K resistor (red-yellow-orange-red).
Carefully bend the leads close to the resistor body as in Step #1.
• 022. Insert R10 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 023. Locate resistor R13. This is 24.3K resistor (red-yellow-orange-red).
Carefully bend the leads close to the resistor body as in Step #1.
• 024. Insert R13 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 025. Locate resistor R14. This is 24.3K resistor (red-yellow-orange-red).
Carefully bend the leads close to the resistor body as in Step #1.
• 026. Insert R14 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 027. Locate resistor R15 This is 24.3K resistor (red-yellow-orange-red).
Carefully bend the leads close to the resistor body as in Step #1.
• 028. Insert R15 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 029. Locate resistor R6. This is 1.82M resistor (brown-gray-red-yellow).
Carefully bend the leads close to the resistor body as in Step #1.
• 030. Insert R6 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
• 031. Locate resistor R9. This is 1.82M resistor (brown-gray-red-yellow).
Carefully bend the leads close to the resistor body as in Step #1.
• 032. Insert R9 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.